laboratory Incubators

Incubators

GRAVITY & FORCED CONVECTION INCUBATORS


EXTERIOR
Robust, easy to clean semi-gloss finish. Powder coated cream or to customer's requirements.

OUTER DOOR
Well supported with robust hinges to give long life and eliminate sag. The door seals with a magnetic surround and non protruding easy opening stainless finger strip.

CONTROL PANEL
Mounted above door to give eye level vision of instruments. Solid state temperature control with digital readout and touch switch temperature selection. Controller easy to remove for quick replacement if needed. A push button reset overheat thermostat is mounted on the control panel.

INSULATION
50 mm thick grade fibreglass for minimum heat loss.

INTERIOR
All stainless steel with clear floor space for special equipment.

INNER DOOR
The glass door is fitted with robust hinges. A catch ensures positive seal against rubber surround.

SHELVES
Chrome plated straight wire type shelves allow maximum circualtion.

FORCED CONVECTION
Fan motor, rubber mounted for very quiet running.

Model No.
Temperature Range
Internal Dimensions HxWxD cm
External Dimensions HxWxD
Capacity Litres
Number Shelf Positions
Number Shelves Supplied
Power Rating (Watts)
14
AMB.-70°C
20x25x20
40x36x30
10
3
2
200
15
AMB.-80°C
35x30x30
65x43x42
31.5
3
2
200
16
AMB.-80°C
46x38x35
75x51x46
60
4
2
300
17
AMB.-80°C
60x50x50
90x63x62
150
5
3
600
18
AMB.-80°C
90x60x50
120x73x62
270
6
4
950
19
AMB.-80°C
120x60x60
150x73x70
432
8
4
1300

Standard units 240V 50Hz AC.
Typical Temperature Fluctuation ±0.1°C at 37°C.
Typical Temperature Variation ±0.5°C at 37°C.

GRAVITY CONVECTION INCUBATORS
Spiral type elements in the heating chamber are used for even temperature distribution. Accurate control is obtained with either a snap action hydraulic thermostat solid state analog instrument or digital indicator controller. This type can be supplied with stirrer (mechanical convection).

LARGE CAPACITY INCUBATORS
Information on incubators with a greater working volume will be provided on request.